Elinchrom RX 1200 Instructions d'exploitation télécharger pdf (Page 10)

Flashheads

When plugging in a lamphead connector, rst push in the front part, then rmly press in the whole

plug, the rear part being secured by the locking spring.

Do NOT plug in or unplug lampcords

while the green leds on output A and B

are ON (illuminated)

Socket

• The ashheads cannot be insulated against humidity and dust.

• Do NOT plug in or unplug lampcords while the green leds on output A and B

are ON (illuminated).

• Never store liquids or drinks on the power pack panel or closed to the unit!

• Do not use near ammable/explosive material (min. 1m distance of any object)

• For your safety, use only Elinchrom ashheads.

• Do not open the unit. In the event of damage or apparent failure, contact a

repair service or any Elinca agent or email: [email protected]

Safety Precautions

Halogen modelling lamp

Use only the recommended modelling lamp, the Digital S and Digital SE heads

are tted with a 300 W halogen modelling lamp. For 230 V code 23022.

Protective dome

Protective Pyrex Dome

For use with standard halogen lamp GX 6.35 socket.

Transparent, matt or yellow (400° K colour correction), can be tted to all lampheads, except

R heads for which clear or matt security lters are available.

Easy attachment of the protective dome:

• Disconnect the lamphead from the pack

• Loosen the 3 screws of the lamphead reector

• Fit the clips underneath the screw heads and tighten the screws

• Put the dome in place and hook the springs into the airvent holes.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Elinchrom RX 1200 Instructions d'exploitation Page 10